Skip to main content

Lead Paint Common Sense

Contact Inspect it All if you want your home inspected or
tested for lead paint. 
Since 1978, lead-based paint has been banned in the United States, so there is practically no risk in newer homes, except from older painted furniture. Homes built between 1950 and 1978 are likely to have lead-based paint, while ones built before 1950 almost certainly have lead-based paint. 

 Lead was used in all kinds of paint, so any older, painted surface is suspect. Cracked or peeling paint poses the most obvious threat. 

There is also risk when an older painted surface is sanded, scraped or sawed as part of a painting, repair or improvement project. In addition, windows can be problems because friction in the sashes slowly grinds up layers of old paint–some of which may contain lead. The resulting contamination can be easily inhaled or ingested.

Lead tends to build up in the body causing a wide variety of mental and physical health problems. The risk is greatest for children under seven and for pregnant women, but lead is bad for everyone. In fact, more ill effects are being discovered all the time.  One long-term strategy for minimizing the problem is to maintain all painted surfaces so that older paints don’t get a chance to crack and peel.

Lead Paint Containment

Anytime a repair or improvement project involving cutting, sanding or scraping of older painted surfaces is going to take place, try to seal off the area with plastic tarps. This way the dust cannot travel indiscriminately throughout the house or yard. When the job is finished, the tarps should be carefully folded and discarded. Use a spray bottle of water to wet surfaces in order to minimize airborne dust levels.

Some power tools, such as sanders, can now be purchased with built-in vacuum systems that capture the dust as it is created. To be effective against lead, the vacuum system must be marked as being of the HEPA (High Efficiency Particulate Air Filter) type.

Personal Protection Against Lead Paint

If you are going to spend time in the work zone, you should wear a respirator with a HEPA filter. A regular face mask won’t do much good.  Also, if there is a lot of dust or if you’re certain contains lead, consider wearing disposable coveralls.  If you don’t wear disposable coveralls, remove all work clothes as you leave the work area and wash them separately from other clothes.  Generally, you want to keep dust levels at a minimum. After any kind of work has been done, it becomes critical to clean up thoroughly and immediately. The best strategy is to use a high phosphate detergent like TSP (trisodium-phosphate, available at hardware and paint stores) or automatic dishwasher soap and thoroughly wipe all surfaces.

Remember to never use a standard vacuum cleaner, as it just stirs up the dust and redistributes it more widely throughout the house. Only HEPA vacuum cleaners are effective for picking up and trapping lead paint dust.
Labels:

Comments

Post a Comment

Popular posts from this blog

Clearing the Air: Indoor Air Quality Concerns After Water and Fire Damage

  When a home or business experiences water or fire damage, the immediate focus is often on the visible destruction. Charred walls, soaked carpets, and ruined possessions dominate our attention. However, a significant but less obvious concern is the impact these events have on indoor air quality (IAQ). Addressing these concerns is crucial for health, safety, and a successful restoration process. The Unseen Dangers: Indoor Air Contaminants 1. Mold and Mildew Water damage, whether from floods, burst pipes, or firefighting efforts, creates a perfect breeding ground for mold and mildew. These fungi thrive in damp, warm environments and can start growing within 24-48 hours after water exposure. Mold spores are airborne and can cause respiratory issues, allergic reactions, and other health problems, especially for those with preexisting conditions like asthma. 2. Smoke and Soot Fire damage leaves behind more than just ashes. Smoke and soot particles can infiltrate your HVAC system, carp...
Post a Comment
Read more

Common places for moisture - in the Attic, Basement and Crawl space

Moisture is a pervasive problem that can wreak havoc on your home if not addressed promptly. It can lead to structural damage, mold growth, and a host of health issues. Three of the most common areas where moisture problems often arise are the attic, basement, and crawl space. Understanding the causes and solutions for moisture in these areas can help you maintain a healthy and safe home environment. The Attic Causes of Moisture in the Attic Roof Leaks: One of the most common causes of moisture in the attic is a leaky roof. Damaged shingles, flashing, or vents can allow water to seep in during rainstorms. Poor Ventilation: Attics require proper ventilation to expel warm, moist air. Without adequate ventilation, moisture can accumulate, especially in colder months when warm air from the living space rises. Improper Insulation: Insufficient or improperly installed insulation can lead to condensation. When warm air from the house meets the cold surfaces of the attic, it can create mois...
Post a Comment
Read more

Is there a difference between Mold and Mildew?

With water damage claims on the rise, we hear a lot of talk these days about the dangers of mold.  Within 24 to 48 hours of water damage, mildew and mold can start growing on wood products, tiles, drywall, carpets, fabrics and other organic materials.  Even worse, it will continue to grow until steps are taken to eliminate the source of moisture, and effectively deal with the problem.  So what is the difference between mold and mildew?  Plain and simple, mildew and mold are both fungi. Fungi can live in many different types of environments such as in soil, on vegetation, and on surfaces exposed to moist conditions like a wall or ceiling after flood damage. Fungi reproduce by spores and can spread quickly. What is Mildew?  Mildew is mold in its early stage and often the term is used interchangeably with the word mold. That whitish-gray, powdery substance sometimes seen on the leaves of a plant is mildew. Mildew is a surface fungi that grows on organic material li...
Post a Comment
Read more